FLOOR SHIFTER for standard HK Kingswood 3speed.

[HK_LS1]

hi guys, in need of some help....

got a HK kingsy with the stock engine and 3 speed manual column shift...

linkages are Fking hammered.... as per usuall...

wanting to find an aftermarket floor shifter, cut a hole into the floor... maybe the seat too if i have too (havnt looked yet where it lines up)

or is there any place where i can buy BRAND NEW linkage set up?
(would rather the floor shifter option though)

has anyone done this? and what shifter did you use? and where did you buy it from?

any help appriciated. thx!

[ljgtr]

http://www.speco.com.au/accshifts.html#threespeed

That's what we used to use years ago..
The next step will be a 4 speed lol..
All so you might try rare spares, they might have a linkage kit for the 3 speed..

[HK_LS1]

http://www.speco.com.au/accshifts.html#threespeed

That's what we used to use years ago..
The next step will be a 4 speed lol..
All so you might try rare spares, they might have a linkage kit for the 3 speed..

thx for the reply mate,
just another question... did u have to cut the bench seat for the shifter ??
or was it pushed forward enough to not touch?

and i think rare spares dont have them, but ill give them a ring.

thx.

[ljgtr]

No you don't, but don't quote me on that lol..
I think it makes it, but to be honest I can't remember..
They might be able to tell you..

[HK_LS1]

No you don't, but don't quote me on that lol..
I think it makes it, but to be honest I can't remember..
They might be able to tell you..

just my luck...

they dont make them anymore.